UNIT INDEX

    What does 6 centimetres look like?

    6 cm across 1 Credit Card

    How long is 6 centimetres?

    6 centimetres is easier to picture beside familiar, measured objects, venues, vehicles, and landmarks.

    6-Centimetre Distance Comparisons

    • 6 centimetres is about 92% of the minimum diameter of a tennis ball.

      Its published measurement is 6.54 centimetres; the ratio is calculated from that figure.

      Source: International Tennis Federation

    • Measured against the short edge of an ISO ID-1 payment card, 6 centimetres spans about 1.1 times that reference.

      Using the source measurement of 5.4 centimetres, this comparison puts the target at 1.1 of it.

      Source: International Organization for Standardization

    • For scale, 6 centimetres is about 2.8 times the diameter of a 5-cent euro coin.

      Its published measurement is 2.13 centimetres; the ratio is calculated from that figure.

      Source: European Commission

    • For scale, 6 centimetres is about 41% of the long side of an A6 sheet.

      Its published measurement is 14.8 centimetres; the ratio is calculated from that figure.

      Source: International Organization for Standardization

    • 6 centimetres is about 43% of the long side of a €50 note.

      Using the source measurement of 14 centimetres, this comparison puts the target at 43% of it.

      Source: European Central Bank

    • Measured against the long side of a €200 note, 6 centimetres spans about 39% of that reference.

      Its published measurement is 15.3 centimetres; the ratio is calculated from that figure.

      Source: European Central Bank

    • For scale, 6 centimetres is about 2.6 times the diameter of a 1-euro coin.

      Its published measurement is 2.32 centimetres; the ratio is calculated from that figure.

      Source: European Commission

    • 6 centimetres is approximately 2.4 inches.

      Using the exact conversion that 1 centimetre equals exactly 0.3937007874 inches, the unrounded result is 2.362 inches.

    Reference measurements are rounded where appropriate, and naturally variable objects are described as approximate, typical, or maximum sizes.