UNIT INDEX

    What does 1 metre look like?

    1 metre across 1 Guitar

    How long is 1 metre?

    1 metre is easier to picture beside familiar, measured objects, venues, vehicles, and landmarks.

    1-Metre Distance Comparisons

    • Measured against the height of a badminton net at centre, 1 metre spans about 66% of that reference.

      The comparison uses the published dimension, converted into the same unit before the proportion is calculated.

      Source: Badminton World Federation

    • For scale, 1 metre is about 2.4 times the long side of an A3 sheet.

      The comparison uses the published dimension, converted into the same unit before the proportion is calculated.

      Source: International Organization for Standardization

    • For scale, 1 metre is about 36% of the length of a table-tennis table.

      Using the source measurement of 2.74 metres, this comparison puts the target at 36% of it.

      Source: International Table Tennis Federation

    • For scale, 1 metre is about 33% of the height of a regulation basketball rim.

      The comparison uses the published dimension, converted into the same unit before the proportion is calculated.

      Source: FIBA

    • 1 metre is about 3.4 times the short side of an A3 sheet.

      Its published measurement is 0.3 metres; the ratio is calculated from that figure.

      Source: International Organization for Standardization

    • 1 metre is about 3.4 times the long side of an A4 sheet.

      Using the source measurement of 0.3 metres, this comparison puts the target at 3.4 of it.

      Source: International Organization for Standardization

    • 1 metre is about 28% of the diameter of the ESO 3.6-metre telescope.

      The comparison uses the published dimension, converted into the same unit before the proportion is calculated.

      Source: European Southern Observatory

    • 1 metre is approximately 3.3 feet.

      Using the exact conversion that 1 metre equals exactly 3.280839895 feet, the unrounded result is 3.281 feet.

    Reference measurements are rounded where appropriate, and naturally variable objects are described as approximate, typical, or maximum sizes.